DUPONT E I DE NEMOURS & CO INC AUTOMOTIVE PRODS D -- 520U IMRON POLYURETHANE ENAMEL TINTS  -- 8010-00F003585
<pre>=====================  Product Identification  =====================

Product ID:520U IMRON POLYURETHANE ENAMEL TINTS
MSDS Date:01/01/1995
FSC:8010
NIIN:00F003585
=== Responsible Party ===
Company Name:DUPONT E I DE NEMOURS & CO INC AUTOMOTIVE PRODS D
Address:BRANDYWINE BLDG 3332 1007 MARKET ST
City:WILMINGTON
State:DE
ZIP:19898-5000
Country:US
Info Phone Num:800-441-7515/800-441-3637
Emergency Phone Num:800-441-3637/800-441-7515
Preparer's Name:T R LOUER
CAGE:23027
=== Contractor Identification ===
Company Name:DU PONT E I DE NEMOURS & CO FABRICATED PROD DEPT
Address:1007 MARKET ST BRANDYWINE BLDG 3332
Box:City:WILMINGTON
State:DE
ZIP:19898
Country:US
Phone:800-441-3637
CAGE:90227
Company Name:TETRA MFG CORP (CAGE CANCELLED)
Address:CAGE CANCELLED
City:WESTBURY
State:NY
ZIP:11590
Country:US
Phone:NONE
CAGE:23027

=============  Composition/Information on Ingredients  =============

Ingred Name:ACRYLIC ACID-BUTYL ACRYLATE-2-HYDROXYETHYL ACRYLATE-STYRENE
    POLYMER	    *96-3*
CAS:25067-83-8

Ingred Name:ALUMINUM	*96-3*
CAS:7429-90-5
RTECS #:BD0330000
Fraction by Wt: 10%
OSHA PEL:15 MG/CUM
ACGIH TLV:10 MG/CUM (DUST)

Ingred Name:SOLVENT NAPHTHA, PETROLEUM, LIGHT AROMATIC, HIGH FLASH
    AROMATIC NAPHTHA, C8&10 AROMATIC HYDROCARBON	    *96-3*
CAS:64742-95-6
RTECS #:WF3400000

Ingred Name:MEDIUM ALIPHATIC NAPHTHA (AROMATIC 100), PARAFFIN-NAPTHANES
    MINERAL SPIRITS   * 96-3 *
CAS:64742-88-7
Other REC Limits:100 PPM
OSHA PEL:500 PPM
ACGIH TLV:100 PPM

Ingred Name:BUTANOL, N-BUTYL ALCOHOL, PROPYL CARBINOL, BUTYL ALCOHOL
CAS:71-36-3
RTECS #:EO1400000
Fraction by Wt: 2%
Other REC Limits:300 MG/CUM
OSHA PEL:100 PPM
ACGIH TLV:C 152 MG/CUM
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:PROPYLENEGLYCOL MONOMETHYL ETHER ACETATE,
    1-METHOXY-2-PROPANOL ACETATE
CAS:108-65-6
RTECS #:AI8925000

Ingred Name:TOLUENE (IARC CARC- GROUP 3)     *96-3*
CAS:108-88-3
RTECS #:XS5250000
Fraction by Wt: 1%
Other REC Limits:375 MG/CUM
OSHA PEL:100 PPM
ACGIH TLV:100 PPM
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:XYLENE, DIMETHYLBENZENE, XYLOL     (IARC - GROUP 3)  *96-3*
CAS:1330-20-7
RTECS #:ZE2100000
Fraction by Wt: 4%
Other REC Limits:100 PPM
OSHA PEL:100 PPM
ACGIH TLV:100 PPM, SKIN
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

=====================  Hazards Identification  =====================

Routes of Entry: Inhalation:YES  Skin:NO  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:INGESTION: GASTROINTESTINAL DISTRESS.
    INHALATION: MAY CAUSE NOSE & THROAT IRRITATION. OVEREXPOSURE TO
    SOLVENTS MAY LEAD TO PERMANENT BRAIN & NERVOUS SYSTEM DAMAGE. EYES:
    IRRITATION/BURNING. SKIN: REPE ATED/PROLONGED CONTACT MAY CAUSE
    IRRITATION W/DISCOMFORT & DERMATITIS.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:GASTROINTESTIAN DISTRESS, IRRITATION, EYE
    WATERING, HEADACHES, NAUSEA, DIZZINESS, LOSS OF COORDINATION,
    BREATHING DIFFICULTY, BURNING, DISCOMFORT

=======================  First Aid Measures  =======================

First Aid:INHALATION: REMOVE TO FRESH AIR. EYES: IMMEDIATELY FLUSH
    W/PLENTY OF WATER FOR 15 MINS. SKIN: WASH W/SOAP & WATER. OBTAIN
    MEDICAL ATTENTION IN ALL CASES.

=====================  Fire Fighting Measures  =====================

Flash Point Method:CC
Flash Point:<100F
Lower Limits:0.9
Upper Limits:13
Extinguishing Media:WATER SPRAY, FOAM, CO2, DRY CHEMICAL
Fire Fighting Procedures:WEAR FULL PROTECTIVE EQUIPMENT W/SCBA. WATER
    FROM FOG NOZZLES MAY BE USED TO COOL CLOSED CONTAINERS TO PREVENT
    PRESSURE BUILD UP.
Unusual Fire/Explosion Hazard:WHEN HEATED >FLASH POINT, EMITS FLAMMABLE
    VAPORS WHICH, WHEN MIXED W/AIR, CAN BURN/BE EXPLOSIVE. FINE
    MISTS/SPRAYS MAY BE FLAMMABLE AT TEMPS <THE FLASHPOINT.

==================  Accidental Release Measures  ==================

Spill Release Procedures:WEAR A POSITIVE PRESSURE SUPPLIED AIR
    VAPOR/PARTICULATE RESPIRATOR (NIOSH/MSHA TC19C), EYE PROTECTION,
    GLOVES & PROTECTIVE MATERIAL. REMOVE SOURCES OF IGNITION. ABSORB
    W/INERT MATERIAL. VENTILATE AREA . POUR LIQUID DECONTAMINANT &
    ALLOW TO SIT 10 MIN.
Neutralizing Agent:DECONTAMINANT: 20% SURFACTANT,80% WATER/0-10%
    AMMONIA,2-5%DETERGENT, BAL-WATER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:DON'T STORE >120F. KEEP AWAY FROM
    HEAT, SPARKS & FLAME. CLOSE CONTAINER AFTER EACH USE. GROUND
    CONTAINERS WHEN POURING. OBSERVE LABEL PRECAUTIONS.
Other Precautions:DON'T SAND, FLAME CUT, BRAZE/WELD DRY COATING W/O A
    NIOSH/MSHA APPROVED RESPIRATOR/APPROPRIATE VENTILATION. PRESSURE
    CAN BE GENERATED. DON'T SEAL CONTAINER. AFTER 48 HOURS, MATERIAL
    MAY BE SEALED & DI SPOSED OF. DON'T BREATHE VAPORS/MISTS.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:A PROPERLY FITTED VAPOR/PARTICULATE RESPIRATOR
    APPROVED BY NIOSH/MSHA (TC-23C) FOR USE W/PAINTS DURING APPLICATION
    & UNTIL VAPORS/SPRAY MISTS ARE EXHAUSTED. CONFINED SPACES/SPRAY
    OPERATIONS: A POSITIV E-PRESSURE, SUPPLIED AIR RESPIRATOR.
Ventilation:SUFFICIENT VENTILATION IN VOLUME & PATTERN TO KEEP
    CONTAMINANTS <APPLICABLE OSHA REQUIREMENTS.
Protective Gloves:NEOPRENE
Eye Protection:SPLASH GUARDS/SIDE SHIELDS
Other Protective Equipment:COVERALLS
Work Hygienic Practices:WASH THOROUGHLY AFTER HANDLING & BEFORE
    EATING/SMOKING.
Supplemental Safety and Health
DON'T PERMIT ANYONE W/O PROTECTION IN THE PAINTING AREA.

==================  Physical/Chemical Properties  ==================

Boiling Pt:B.P. Text:169F-374F
Vapor Density:>1
VOC Grams/Liter:4.5
Evaporation Rate &amp; Reference:LESS THAN ETHER
Solubility in Water:MISCIBLE
Percent Volatiles by Volume:61-69

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
Stability Condition to Avoid:HEAT, SPARKS, FLAME & OTHER IGNITION
    SOURCES
Hazardous Decomposition Products:CO, CO2, SMOKE

====================  Disposal Considerations  ====================

Waste Disposal Methods:DON'T ALLOW MATERIAL TO CONTAMINATE GROUND WATER
    SYSTEMS. INCINERATE ABSORBED MATERIAL IAW/LOCAL, STATE & FEDERAL
    REGULATIONS. DON'T INCINERATE IN CLOSED CONTAINERS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.